LATEST

Showing posts with label Electrical Circuits. Show all posts
Showing posts with label Electrical Circuits. Show all posts

Thursday, July 2, 2020

July 02, 2020

Electrical Circuits MCQs Part 03

Electrical Circuits MCQs Part 03



21. Two capacitors of capacitance 9 µF and 18 µF in series will have a total capacitance of
A. 27 µF
B. 162 µF
C. 6 µF
D. 180 µF

22. In a series RLC circuit
A. Increasing the frequency decreases the resistance
B. Increasing the frequency increases the resistance
C. Both Xand XC change as frequency changes
D. Impedance will always decrease

23. A series RLC circuit has a ________ power factor at its half-power points
A. Unity
B. Leading
C. Lagging
D. Either B or C

24. Kirchhoff’s laws (KCL and KVL) are applicable to
A. DC circuits
B. AC circuits
C. DC as well as AC circuits
D. Passive networks alone

25. A tank circuit is a
A. Parallel LC circuit
B. Series LC circuit
C. A resonant circuit
D. A non-resonant circuit

26. A capacitive load always has a _________    power facto
A. Leading
B. Lagging
C. Zero
D. Unity

27. What is the temperature coefficient of the resistance Eureka?
A. Infinity
B. Negative
C. Almost zero
D. Positive

28. As applied to a series RLC circuit, bandwidth means
A. The frequency range for maximum power transfer
B. The difference between the highest and lowest frequencies of the oscillator
C. The separation of the half-power points
D. The frequency at which XL = XC

29. Which is considered as the effect of a dielectric material?
A. Increasing capacitance
B. Decreasing capacitance
C. Reducing the working voltage
D. Increasing the distance between the plates

30. The open-circuit voltage at the terminal of load RL is 60V.    Under the condition of maximum power transfer, the load voltage will be
A. 60 V
B. 15 V
C. 20 V
D. 30 V
July 02, 2020

Electrical Circuits MCQs Part 02

Electrical Circuits MCQs Part 02



11. What is the other name of relative permittivity?
A. Dielectric strength
B. Potential gradient
C. Breakdown voltage
D. Specific inductance capacity
12. In a series RLC circuit
A. The current lags VL by 90˚
B. The current leads VL by 90˚
C. XL leads Xc by 90˚
D. Z = jXL at resonance

13. Resistor with colored bands in the body
A. Wire-wound resistor
B. Carbon-composition resistor
C. Potentiometer
D. Rheostat

14. In a resonant circuit, if Q ≥ 10 resonant frequency __________    bandwidth.
A. Bisects
B. Exceeds
C. Is less than
D. Is equal to

15. Which of the following conditions is not true for a series RLC circuit at resonance?
A. Z = jXL
B. XL = XC
C. The power factor is one
D. The magnitude of Z is √(R^2+〖(XL-XC)〗^2 )

16. The current is ____ times the maximum current at half-power points of a resonance curve.
A. 0.707
B. 1.414
C. 0.5
D. 0.632

17. A gang capacitor is a variable capacitor in which capacitance is varied by changing the
A. Dielectric
B. Number of plates
C. Plate area
D. Distance between plates

18. In an ac circuit with inductive reactance, the
A. Phase angle of the circuit is always 45˚
B. Voltage across the inductance must be 90˚ out-of-phase with the applied voltage
C. Current through the inductance lags its induced voltage by 90˚
D. Current through the inductance and voltage across it are180˚ out-of-phase

19. If three 9 mH inductors are connected in parallel without mutual inductance then the total inductance is
A. 3 mH
B. 9 mH
C. 27 mH
D. 18 mH

20. What is the specific resistance of a pure germanium?
A. 55 Ω-cm
B. 55 Ω -m
C. 5 Ω -mm
D. 55 k Ω -m
July 02, 2020

Electrical Circuits MCQs Part 01

Electrical Circuits MCQs Part 01


1. Conventional flow assumes charges flow from
A. Positive to negative
B. Positive to positive
C. Negative to positive
D. Negative to negative

2. Electron flow assumes charges flow from
A. Negative to positive
B. Negative to negative
C. Positive to negative
D. Positive to positive

3. Series resonance occurs when
A. XL = XC
B. XL = R
C. Z = R
D. Both A and C

4. The symbol Q refers to
A. Resonance quotient
B. Quality factor
C. Power quotient
D. Qualification test

5. The ratio of W/VA in an ac circuit means
A. Power factor
B. Reactive factor
C. Quality factor
D. Load factor

6. What is the reciprocal of quality factor?
A. Power factor
B. Reactive factor
C. Dissipation factor
D. 1/Q factor

7. In liquids and gases, ionization current results from a flow of
A. Positive or negative ions
B. Free electrons
C. Ions that are lighter in weight than electrons
D. Protons

8. VL = VC in a series RLC circuit when
A. The value of the impedance is minimum
B. The power factor is zero
C. The current leads the total voltage by 90˚
D. The total voltage is zero

9. At what frequency will an inductor of 5mH have the same reactance as a capacitor of 0.1 µF?
A. 7.12 kHz
B. 7.12 Hz
C. 7.12MHz
D. 7.12 GHz

10. Property of an electric circuit that dissipates electric energy
A. Reactance
B. Impedance
C. Resistance
D. Conductance